| Previous | Table of Contents | Next |
EIDEMAX
| Data bus: | 16-bit, ISA |
| Size: | Half-length, half-height card |
| Hard drive supported: | Two IDE (AT) Interface drives |
| Floppy drives supported: | None |
| CONNECTIONS | |
|---|---|
| Function | Location |
| 40-pin IDE(AT) interface connector | J1 |
| 4-pin connector - drive active LED | JP1 |
| USER CONFIGURABLE SETTINGS | ||
|---|---|---|
| Function | Location | Setting |
 IDE(AT) interface enabled |
JP3/A | pins 1 & 2 closed |
| IDE(AT) interface disabled | JP3/A | pins 2 & 3 closed |
| EIDEMAX is primary IDE(AT) interface in system |
JP3/B | pins 1 & 2 closed |
| EIDEMAX is secondary IDE(AT) interface in system | JP3/B | pins 2 & 3 closed |
| On-board BIOS enabled |
JP5 | pins 1 & 2 closed |
| On-board BIOS disabled | JP5 | pins 2 & 3 closed |
| INTERRUPT SELECTION | |||
|---|---|---|---|
| IRQ | JP2/A | JP2/B | JP2/C |
| IRQ15 |
closed | open | open |
| IRQ12 | open | open | closed |
| IRQ14 | open | closed | open |
| BASE MEMORY ADDRESS SELECTION | ||
|---|---|---|
| Address | JP4/A | JP4/B |
| D0000h |
pins 2 & 3 closed | pins 2 & 3 closed |
| D4000h | pins 2 & 3 closed | pins 1 & 2 closed |
| D8000h | pins 1 & 2 closed | pins 2 & 3 closed |
| DC000h | pins 1 & 2 closed | pins 1 & 2 closed |
SCSIMAX PREMIER SCSI
SCSI ULTRA PREMIER SCSI
| Data Bus | 32-bit PCI |
| Card Size | Half-height, quarter-length card |
| Hard Drives supported | Up to 15 Fast & Wide SCSI 2 drives (SCSIMAX) |
| Up to 15 Ultra SCSI-2/SCSI-3 drives (SCSIULTRA) | |
| Floppy drives supported | None |
| CONNECTIONS | |||
|---|---|---|---|
| Function | Location | Function | Location |
| 68-pin SCSI connector - external | J1 | 50-pin SCSI connector - internal | J3 |
| 68-pin SCSI connector - internal | J2 | 4-pin connector - drive active LED | LED1 |
| USER CONFIGURABLE SETTINGS | ||
|---|---|---|
| Function | Label | Position |
| The termination is enabled |
SW1 | On |
| The termination is disabled | SW1 | Off |
| Note: Facing the bracket, SW1 On position is to the left and Off position is to the right. | ||
| MISCELLANEOUS TECHNICAL NOTES |
|---|
| Note: When combining internal and external devices, only one of the internal connectors can be used. |
| Previous | Table of Contents | Next |
