Previous

Table of Contents

Next

ACCULOGIC SIDE-2/PCI

Data bus:	32-bit PCI
Size:	Half-length, half-height card
Hard drive supported:	Four IDE (AT) drives
Floppy drives supported:	None

CONNECTIONS
Function	Location
40-pin primary IDE (AT) connector	J1
2-pin connector - drive active LED	J2
40-pin secondary IDE (AT) connector	J3
10-pin ISA IRQ board connector	J5

 

USER CONFIGURABLE SETTINGS
Function	Location	Setting
Factory configured - do not alter	J4	N/A

 

ADDRESS MODE SELECTION
Mode	W2/A	W2/B
ISA IDE	off	on
Native mode	on	off

 

PCI PRIMARY INTERRUPT SELECTION
INT	W3/A	W3/B	W3/C	W3/D
ISA IRQ 14	off	off	off	off
A	on	off	off	off
B	off	on	off	off
C	off	off	on	off
D	off	off	off	on

 

PCI SECONDARY INTERRUPT SELECTION
INT	W4/A	W4/B	W4/C	W4/D
ISA IRQ 15	off	off	off	off
A	on	off	off	off
B	off	on	off	off
C	off	off	on	off
D	off	off	off	on

 

MISCELLANEOUS TECHNICAL NOTES
If IRQ 14 or 15 is selected, the ISA IRQ board is required. This board connects the primary IDE interrupt to the ISA bus IRQ 14 and secondary IDE interrupt to ISA bus IRQ 15.

 

ACCULOGIC SIDE-3/PLUS

Data bus:	16-bit, ISA
Size:	Half-length, half-height card
Hard drives supported:	Two IDE (AT) drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, 1.44MB or 2.88MB

CONNECTIONS
Function	Location
4-pin connector-Drive Active LED	J1
40-pin AT Interface (IDE) connector	J2
34-pin control cable connector-floppy drive	J3

 

BIOS ADDRESS
Address	Jumper JP12	Jumper JP13
C800h	open	open
CC00h	open	closed
D800h	closed	open
DC00h	closed	closed

 

USER CONFIGURABLE SETTINGS
Function	Location	Setting
Floppy drive port address is 3F0-3F7h	JP6	open
Floppy drive port address is 370-377h	JP6	closed
Hard drive port address is 1F0-1F7h	JP7	open
Hard drive port address is 170-177h	JP7	closed
Single speed floppy drives supported	JP8	open
Dual speed floppy drives supported	JP8	closed
Floppy drive precompensation is 125ns	JP9	open
Floppy drive precompensation is 187ns	JP9	closed
I/O channel ready signal disabled	JP10	open
I/O channel ready signal enabled	JP10	closed
BIOS enabled	JP11	open
BIOS disabled	JP11	closed
2.88MB drives not supported on A:	JP14	open
2.88MB drives supported on A:	JP14	closed
2.88MB drives not supported on B:	JP15	open
2.88MB drives supported on B:	JP15	closed

 

IRQ14 STATUS
Function	Jumper JP1	Jumper JP2
IRQ14 normal	closed	open
IRQ14 delayed until ACTIVE signal is removed	open	closed

 

MISCELLANEOUS TECHNICAL NOTES
This controller has no on-board software.